HP Value Serial/USB Receipt Printer II Uživatelský manuál Strana 45

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 155
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 44
Chapter 3: Programming Commands 45
Select pitch (column width)
ASCII ESC SYN n
Hexadecimal 1B 16 n
Decimal 27 22 n
Value of n: 0 = Standard pitch
1 = Compressed pitch
Default: 0 (Standard pitch)
Selectsthecharacterpitchforaprintline.
Formulas
The following table provides the print characteristics for both pitches on the receipt station.
Pitch Columns, CPI
80mm Paper
Standard 44 15.6
Compressed 56 20.3
Related information
SeeChapter2:ProgrammingthePrinter,“Characterappearance”foradescriptionofbothpitches.
Thiscommandandtheselectprintmodescommand(1B21n) affect pitch selection.
ThisisignoredinLEGACYemulationandtheparameterbytegoesintotheprintbuffer.
Set right-side character spacing
ASCII ESC SP n
Hexadecimal 1B 20 n
Decimal 27 32 n
Range of n: 0 – 32 (decimal)
Default: 0
Theunitsofhorizontalandverticalmotionarespeciedbythesethorizontalandverticalminimummotionunits(1D
50…)command.Changesinthehorizontalorverticalunitsdonotaffectthecurrentrightsidecharacterspacing.When
thehorizontalorverticalmotionunitischangedbythesethorizontalandverticalminimummotionunits(1D50…)
commandthevaluemustbeinevenunitsandnotlessthantheminimumamountofhorizontalmovement.
Instandardmodethehorizontalmotionunitisused.
Inpagemodethehorizontalorverticalmotionunitdiffersanddependsonthestartingpositionoftheprintablearea.When
thestartingprintingpositionistheupperleftorlowerrightoftheprintablearea(setbyselectprintdirectioninpagemode,
1B54n)thehorizontalmotionunit(x) is used. When the starting printing position is the upper right or lower left of the
printablearea(setbyselectprintdirectioninpagemode,1B54n)theverticalmotionunit(y) is used.
Thiscommandcanbesetindependentlyinstandardmodeandinpagemode.
Whencharactersareenlarged,theright-sidecharacterspacingisamultipleofitsnormalvalue(ex.spacingfordouble-
width mode is twice the normal value).
Related information
ThiscommanddoesnotaffectHRIcharacters.
ThisisignoredinLEGACYemulationandtheparameterbytegoesintotheprintbuffer.IntheA793emulation,the
commandandparameterbyteareignored.
Zobrazit stránku 44
1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 154 155

Komentáře k této Příručce

Žádné komentáře