
Viewing the audit log
The Storage Module for vCenter provides an audit log for provisioning operations. The audit log,
provisionAuditLog.txt, is available in the following directory:
install directory/Storage/JBoss/standalone/log.
Creating a datastore
You can add a new datastore to a host or cluster that meets the following prerequisites.
Hosts
• The host must exist in the vSphere Client.
• In an FC environment, the SAN must be zoned between the storage pools and the host.
• The host must be configured as a hostgroup or host on the array.
• P4000 arrays in an iSCSI environment only:
The iSCSI initiator on the host must be installed and configured.◦
◦ The iSCSI array IP address or hostname must be configured in the iSCSI initiator's dynamic
discovery list on the host.
Clusters
• The cluster and its hosts must exist in the vSphere Client.
• In an FC environment, the SAN must be zoned between the storage pools and the cluster
hosts.
• The cluster hosts must be configured as hostgroups or hosts on the array.
• The cluster hosts can belong to separate hostgroups.
NOTE: The Storage Module for vCenter does not support configurations that have all cluster
hosts in a single hostgroup.
• P4000 arrays in an iSCSI environment only:
The iSCSI initiator on all cluster hosts must be installed and configured.◦
◦ The iSCSI array IP address or hostname must be configured in the iSCSI initiator's dynamic
discovery list on all cluster hosts.
Creating a datastore
To add a datastore to a host or cluster:
1. Start the vSphere Client.
2. Use one of the following methods to start the Add Datastore wizard:
• Right-click a host or cluster and select HP Insight Management→Create Datastore.
• Select Actions→Create Datastore on the HP Insight Management page for a host or cluster.
• Right-click a host or cluster in any Storage Module for vCenter table, and then select
Create Datastore.
The Create Datastores – Specify Storage window opens. See Figure 35 (page 68).
Viewing the audit log 67
Komentáře k této Příručce