Hp OneView for VMware vCenter Uživatelský manuál stáhnout pdf (Strana 79)

2. Use one of the following methods to start the Clone Virtual Machine wizard:

• Select Actions→Clone VM on the HP Insight Management page for a host or cluster.

• Right-click a VM and select HP Insight Management→Clone VM.

• Right-click a VM in any Storage Module for vCenter table, and then select Clone VM.

The Clone Virtual Machine – Clone Parameters window opens. See Figure 48 (page 79).

Figure 48 Clone Virtual Machine – Clone Parameters window

3. Enter the following information:

• Target Owner: Select the host or cluster that will own the new VMs.

• Target VM Quantity: Enter the number of VMs to create.

• Target VM Initial State: Specify whether the initial VM state is Power On or Power Off.

• Customization Specification: Specify a customization specification (if available). For more

information, see the VMware documentation.

• Clone Type: Select Snapshot or Clone.

A snapshot is a demand-allocated snapshot that remains associated with the source

volume. A clone is a fully allocated (thin-provisioned) copy that is not associated with the

source volume.

• Storage Pool: The storage pool used by the source VM is displayed automatically along

with the Capacity Before and Capacity After details.

4. Click Next.

The Clone Virtual Machine – Specify New Names window opens. See Figure 49 (page 80).

Cloning a VM 79

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 106 107

Žádné komentáře

Hp OneView for VMware vCenter Uživatelský manuál Strana 79