Hp StorageWorks 500 Modular Smart Array Uživatelský manuál stáhnout pdf (Strana 142)

Troubleshooting

HP StorageWorks Modular Smart Array 500 System User Guide D-9

6. Replace any failed drives.

7. After the failed drives have been replaced, the fault tolerance may again be

compromised. If so, cycle the power again, and if the #02 or #04 controller

display message is displayed, press the right push button. This action re-enables

the logical drive(s).

Automatic Data Recovery

Automatic Data Recovery is an automatic background process that rebuilds data onto

a spare or replacement drive when another drive in the array fails. The hard drive that

is being rebuilt flashes once per second.

If a drive in a fault-tolerant configuration is replaced while the system power is off, a

controller display message appears during the next system startup. Automatic Data

Recovery starts.

When Automatic Data Recovery is completed, the online LED of the replacement

drive stops flashing and illuminates steadily.

In general, the system requires approximately 15 minutes to rebuild each gigabyte.

The actual rebuild time depends upon the following:

• The rebuild priority level (high or low) of the logical drive

• The amount of I/O activity occurring during the rebuild operation

• The disk drive speed

• The number of drives in the array (for RAID 5 and RAID ADG)

For example, the rebuild time for 9-GB Wide-Ultra hard drives in a RAID 5

configuration varies from 10 minutes per gigabyte (for three drives) to 20 minutes per

gigabyte (for 14 drives).

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 156 157

Žádné komentáře

Hp StorageWorks 500 Modular Smart Array Uživatelský manuál Strana 142