HP 16501A LOGIC Uživatelský manuál stáhnout pdf (Strana 54)

7 Select Group Run from the upper right corner of the display.

After the measurement is complete, you can interleave the trace lists of both

state analyzers to see the activity executed by both coprocessors during

related clock cycles.

You can use a similar procedure if you have only one processor, but wish to

monitor its activity with that of other system nodes, such as chip-select lines,

I/O activity, or behavior of a watchdog timer. In some instances it may be

easier to look at related activity with a timing analyzer.

See Also “Special Displays” in this chapter.

“To use a state analyzer to trigger timing analysis of a count-down on a set of

data lines” in this chapter.

Intermodule Measurements

To monitor the activity of two coprocessors in a target system

2–20

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 129 130

Žádné komentáře

HP 16501A LOGIC Uživatelský manuál Strana 54