HP RP7 Retail System Model 7100 Uživatelský manuál stáhnout pdf (Strana 18)

Enter/Exit Programming Mode

HP Retail Integrated Barcode Scanner

To program features:

1. Scan the ENTER/EXIT PROGRAMMING barcode, available at the top of each pro-

gramming page, when applicable.

2. Scan the barcode to set the desired programmin

g feature. You may need to cover

unused barcodes on the page, and possibly the facing page, to ensure that the scanner

reads only the barcode you intend to scan.

3. If additional input parameters are needed, go t

o Appendix D, Keypad, and scan the

appropriate characters from the keypad.

4. Complete the programming sequence by scanning the ENTER/EXIT PROGRAM-

MING barcode to exit Programming Mode.

For more detailed descriptions,

programming information and examples for setting selected

configuration items, see "References" starting on page 179.

You must first enable the scanner to read barcodes in order to use this

section. If you have not done this, go to

"Setup" starting on page 5

and complete the appropriate procedure.

Additional information about many features can be found in the “Refer-

ences” chapter.

If you make a mistake before the last character, scan the CANCEL barcode to

abor

t and not save the entry string. You can then start again at the begin-

ning.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 243 244

Žádné komentáře

HP RP7 Retail System Model 7100 Uživatelský manuál Strana 18