HP RP7 Retail System Model 7100 Uživatelský manuál stáhnout pdf (Strana 188)

References

180

HP Retail Integrated Barcode Scanner

USB-COM Parameters

Intercharacter Delay

This parameter specifies the intercharacter delay between the end of one character and the

beginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in

10ms increments. A setting of zero specifies no delay.

To set the delay:

1. Determine the desired setting in mi

lliseconds.

2. Divide the desired setting by 10 (setting is in

10ms increments). Pad the result with

leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.

3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming

Mode.

4. Go to page 14 and scan the barcode: SELECT

INTERCHARACTER DELAY SET-

TING.

5. Scan the appropriate two digits from the

keypad in Appendix D, Keypad, that repre-

sent the duration which was determined in the

steps above. You will hear a two-beep

indication after the last character.

6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit.

This completes the procedure. See Table 25 for some examples of how to set this feature.

Table 25. Intercharacter Delay Setting Examples

If you make a mistake before the last character, scan the CANCEL barcode to

abort and not save the entry string. You can then start again at the beginning.

STEP ACTION EXAMPLES

1 Desired Setting

50ms 150ms 600ms 850ms

Divide by 10 (pad with leading

eroes to yield two-digits)

05 15 60 85

3 Scan ENTER/EXIT PROGRAMMING MODE

4 Scan SELECT INTERCHARACTER DELAY SETTING

Scan Two Characters From

Appendix D, Keypad

‘0’ and ‘5’ ‘5’ and ‘0’ ‘6’ and ‘0’ ‘8’ and ‘5’

6 Scan ENTER/EXIT PROGRAMMING MODE

1 2 ... 183 184 185 186 187 188 189 190 191 192 193 ... 243 244

Žádné komentáře

HP RP7 Retail System Model 7100 Uživatelský manuál Strana 188