HP RP7 Retail System Model 7100 Uživatelský manuál stáhnout pdf (Strana 38)

Enter/Exit Programming Mode Data Format

HP Retail Integrated Barcode Scanner

Global Prefix/Suffix

This option sets up to 20 characters each from the set of ASCII characters or any hex value

from 00 to FF. The characters may be added as a prefix (in a position before the barcode

data, also called a header) and/or as a suffix (in a position following the barcode data, also

called a footer). See page 190 for more detailed instructions on set

ting this feature.

To configure this feature, scan the ENTER/EXIT PR

OGRAMMING MODE barcode above

to place the unit in Programming Mode, then the “Set Global Prefix” or “Set Global Suffix,”

barcode followed by the digits (in hex) from the Alphanumeric characters in Appendix D,

Keypad representing your desired character(s). If

less than the expected string of 20

characters are selected, scan the ENTER/EXIT barcode to

terminate the string. Exit

programming mode by scanning the ENTER/EXIT barcode again.

Global AIM ID

AIM label identifiers (as opposed to custom characters you select yourself as with label

identifiers) can be included with scanned barcode data. See Table 2 below for a list of AIM

IDs. AIM label identifiers consist of

three characters as follows:

• A close brace character (ASCII ‘]’), followed by...

Set Global Prefix

Set Global Suffix

Make a mistake? Scan the CANCEL barcode to abort

and not save the entry string. You can then start again

at the beginning.

CANCEL

This feature enables/disables addition of AIM IDs for all symbology

types.

$CLFPR

$CLFSU

DEFAULT

No Global Prefix

Global Suffix = 0x0D

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 243 244

Žádné komentáře

HP RP7 Retail System Model 7100 Uživatelský manuál Strana 38