HP RP7 Retail System Model 7100 Uživatelský manuál stáhnout pdf (Strana 192)

References

184

HP Retail Integrated Barcode Scanner

ACK NAK Retry Count

This feature specifies the number of times the scanner retries a label transmission due to a

retry condition. The selectable range is from 1 to 254 retries. A selection of 0 disables the

count, and a selection of 255 specifies unlimited retries.

To set this feature:

1. Determine the desired setting.

2. Pad the number with leading zeroes to yield

three digits. For example: 0 = 000, 5 =

005, 20 = 020, etc.

3. Go to page 18 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter

Programming Mode.

4. Scan the barcode: SELECT ACK NAK RETRY COUNT SETTING.

5. Scan the appropriate three dig

its from the keypad in Appendix D, Keypad, that repre-

sent the number which was determined in the steps above.

You will hear a two-beep

indication after the last character.

6. Scan the ENTER/EXIT PROGRAMMING MODE barcod

e to exit Programming

Mode.

This completes the procedure. See Table 29 for some examples of how to set this feature.

Table 29. ACK NAK Retry Count Setting Examples

If you make a mistake before the last character, scan the CANCEL barcode to

abort and not save the entry string. You can then start again at the begin-

ning.

STEP ACTION EXAMPLES

1 Desired Setting

Disable Retry

Count

3 Retries 54 Retries Unlimited Retries

2 Pad with leading zero(es)

000 003 054 255

3 Scan ENTER/EXIT PROGRAMMING MODE

4 Scan SELECT ACK NAK RETRY COUNT SETTING

Scan Three Characters From

Appendix D, Keypad

‘0’, ‘0’ and ‘0’ ‘0’, ‘0’ and ‘3’ ‘0’, ‘5’ and ‘4’ ‘2’, ‘5’ and ‘5’

6 Scan ENTER/EXIT PROGRAMMING MODE

1 2 ... 187 188 189 190 191 192 193 194 195 196 197 ... 243 244

Žádné komentáře

HP RP7 Retail System Model 7100 Uživatelský manuál Strana 192