Hp Surestore Disk Array 12h and FC60 Uživatelský manuál Strana 169

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 466
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 168
Installing the Disk Enclosures 169
Installation
Note
What if LUN 0 is on disks in the enclosure?
If any of the disks in the enclosure are part of LUN 0, you will not be able to
unbind the LUN before moving the disks. Instead, you must replace LUN 0 and
exclude any of the disks in the enclosures from LUN 0.
4. Power down the disk array, both the array controller enclosure and the disk enclosures.
5. Remove the disk enclosures from the rack. To remove the enclosures, reverse the steps
listed in "Installing the Disk Enclosures" on page 160.
6. Install the disk enclosures in the new rack following the instructions in "Installing the
Disk Enclosures" on page 160. Make sure the disk enclosure is configured properly for
the new disk array.
7. Bind a LUN with the new disks using the management tool of your choice:
To use SAM, see "Binding a LUN" on page 267
To use Array Manager 60, see "Binding a LUN" on page 289
To use STM, see "Binding a LUN" on page 314
Note
After binding a LUN, you must execute the
insf -e
command to install special
device files on the LUN. This makes the LUN usable by the operating system.
Zobrazit stránku 168
1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 465 466

Komentáře k této Příručce

Žádné komentáře