HP EliteDesk 705 G3 Microtower PC Uživatelský manuál stáhnout pdf (Strana 35)

3. Release the slot cover retention latch that secures the slot covers by lifting the tab on the latch and

rotating the latch to the open position.

4. Locate the correct vacant expansion socket on the system board and the corresponding expansion slot

on the back of the computer chassis.

5. Before installing an expansion card, remove the expansion slot cover or the existing expansion card.

NOTE: Before removing an installed expansion card, disconnect any cables that may be attached to

the expansion card.

a. If you are installing an expansion card in a vacant socket, you must slide one of the expansion slot

covers up and out of the chassis or use a at-bladed screwdriver to pry out one of the metal

shields on the rear panel that covers the expansion slot. Be sure to remove the appropriate shield

for the expansion card you are installing.

Expansion cards 27

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 137 138

Žádné komentáře

HP EliteDesk 705 G3 Microtower PC Uživatelský manuál Strana 35