HP C30D Uživatelský manuál stáhnout pdf (Strana 37)

100

101

Printer and Troubleshooting Overview 1-23

5 Remove the photoconductor unit.

Figure 1-4. Producing a Toner Patch on the Photoconductor Unit

6 Examine the photoconductor unit to verify that a toner patch has been produced. You

may have to rotate the belt slightly to observe the patch.

Completing a Service Call

After resolving any printer problem, complete the service call as follows:

1 Reassemble the printer.

2 Perform the every-call cleaning procedure, described in Chapter 9, “General Printer

Maintenance”.

3 If you have removed the printer’s diskette(s), reinstall them.

4 Power-on-reset the printer.

5 Clear the error log. (See the procedure described next.)

6 Run test prints in both the simplex and duplex mode from both the upper and lower

paper cassettes.

7 Fill in the Repair/Maintenance log. Make sure the problem description and steps taken

to resolve the problem are clearly documented.

Do not touch the surface of the photoconductor belt; this

damages the belt and results in poor print quality.

Caution

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 482 483

Komentáře k této Příručce

Žádné komentáře

HP C30D Uživatelský manuál Strana 37

Komentáře k této Příručce

Související produkty a manuály pro Tisk a skenování HP C30D