HP INTEGRITY RX3600 Uživatelský manuál stáhnout pdf (Strana 191)

by preventing inadvertent contact between cards during the replacement, addition, or removal

of a card.

WARNING! Ensure that the system is powered off and all power sources have been disconnected

from the server prior to performing this procedure.

Voltages are present at various locations within the server whenever an ac power source is

connected. This voltage is present even when the main power switch is in the off position.

Failure to observe this warning can result in personal injury or damage to equipment.

CAUTION: Observe all ESD safety precautions before attempting this procedure. Failure to

follow ESD safety precautions can result in damage to the server.

Removing a PCI/PCI-X/PCIe Card Divider

To remove a PCI/PCI-X/PCIe card divider, follow these steps:

1. Power off the server and disconnect the power cables. See “Powering Off the Server”

(page 95).

2. If rack installed, slide the server completely out from the rack. See “Extending the Server

from the Rack” (page 180).

3. Remove the top cover. See “Removing the Top Cover” (page 181).

CAUTION: When extracting the card divider, ensure you release the locking tabs completely

or you can damage them. If you damage the tabs, the divider does not seat properly when

you reinsert it.

4. Use a tool to carefully push the two tabs that attach the card divider to the I/O board

assembly.

5. Pull the card divider up sharply by the handle to disengage it from the I/O board assembly

(Figure 6-9).

Removing and Replacing PCI/PCI-X/PCIe Card Dividers 191

1 2 ... 186 187 188 189 190 191 192 193 194 195 196 ... 355 356

Žádné komentáře

HP INTEGRITY RX3600 Uživatelský manuál Strana 191