HP INTEGRITY RX3600 Uživatelský manuál Strana 214

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 356
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 213
8. Install the DIMM (Figure 6-17).
a. Align the DIMM with the correct slot located on the memory board, and align the key
in the connector with the notch in the DIMM.
b. Firmly and evenly push on each end of the DIMM until it seats into the slot.
c. Ensure the extraction levers are in the locked position.
Figure 6-17 Inserting DIMM into Memory Board Connector
9. Replace the memory carrier assembly side cover.
a. Insert the side cover tabs into the retaining slots at the base of the assembly (Figure 3-8).
b. Insert the tabs (Figure 6-13) into the slots on both sides of the extraction handle release
button until the side cover snaps into place.
NOTE: To install DIMMs into slots on the other side of the memory carrier, turn the carrier
over to the opposite side (side 0 or side 1) and repeat the installation procedure.
10. Replace the memory carrier assembly and latch the top cover release lever closed. See
“Replacing the Memory Carrier Assembly” (page 205).
11. If rack installed, slide the server completely into the rack. See “Inserting the Server into the
Rack” (page 180).
12. Reconnect the power cables and power on the server. See “Powering On the Server
(page 94).
214 Removing and Replacing Server Components
Zobrazit stránku 213
1 2 ... 209 210 211 212 213 214 215 216 217 218 219 ... 355 356

Komentáře k této Příručce

Žádné komentáře