HP INTEGRITY RX3600 Uživatelský manuál stáhnout pdf (Strana 341)

NOTE: The EFI driver’s handle values change on every boot.

TIP: From this command (drvcfg), record these two pieces of information for each channel

of each SCSI interface for parameters to be changed:

• Drv(the EFI driver’s handle)

• Ctrl(the controller’s handle)

4. Using the driver’s handle [Drv] and the controller’s handle [Ctrl] from the

drvcfgcommand, start the EFI SCSI Setup Utility for one channel of this SCSI interface.

At the EFI Shell prompt, enter:

Shell> drvcfg -s drvr_handle cntrl_handle

where:

• drvr_handle: The handle of the driver that controls the channel with the SCSI ID you

want to display or change.

• cntrl_handle: The handle of the controller for the channel with the SCSI ID you want

to display or change.

For channel A of this SCSI interface, enter:

Shell> drvcfg -s 45 18

5. The EFI SCSI Setup Utility starts and its main menu displays, showing a list of all the EFI

capable SCSI interfaces in the system.

Move the cursor to highlight the channel of the SCSI interface. Press Enter to determine

which channel of the interface to highlight, match the PCI Bus, PCI Dev, and PCI Func

values on this screen to the Bus #, Dev #, and Fnc # values from the info io command.

CAUTION: Do not select the <Global Properties> option on the main menu.

TIP: To move the cursor in the EFI SCSI Setup Utility, use the following keys:

• Arrow keys: ↑ ↓ ← →

• Alternate keys:

H = left

J = down

K = up

L = right

I = home

O = end

6. The Adapter Properties screen for this channel of the SCSI interface displays. Be sure the

utility is running for the channel of the SCSI interface by comparing the values shown for

Specifying SCSI Parameters 341

1 2 ... 336 337 338 339 340 341 342 343 344 345 346 ... 355 356

Žádné komentáře

HP INTEGRITY RX3600 Uživatelský manuál Strana 341