HP NonStop Shadowbase Command Definitions
Collector Command Descriptions
HP NonStop Shadowbase Command Reference Manual—785421-002
98
NUM WRTRDS number of completed inter-process messages sent to CONS
and QMGR processes and responded to (i.e.,i.e., the ACK received).
Note that this does not necessarily indicate that this number of messages
that have been fully processed. This is because when
RESOLVELOCKSQ is enabled, messages become completed before they
have been fully processed (i.e.,i.e., the CONS responds almost
immediately after the message has been received).
WRTRD TIME shows the total amount of time for all messages sent to CONS
and QMGR processes and responded to. The duration for a message is
measured from just prior to the message being sent until just after the
response (ACK) has been received.
AVG RESP shows the average response time for messages computed by
dividing the NUM WRTRDS into WRTRD TIME.
Notes:
The Collector will only send the MAXCONSWRITES specified number
of messages to a specific Consumer before waiting for a reply. Only
after receiving a reply will it begin sending another.
DOC ROLL STATUS INFO (NEXT/CURRENT) – This section is only
displayed after a RUN command is issued and a DOC roll schedule is
input or a NEXTDOC command is issued.
SCHEDULE shows the type of roll schedule in use:
ADT – Audit trail based.
TOD – Time of day based.
CMD – User command based.
If ADT or TOD shows, the time of the current or next rollover also
displays. If CMD displays and a DOC roll is in progress, the time
appears. Otherwise, if no DOC roll is in progress, the word
INTERACTIVE is displayed.
LAST AUDITTRAIL REC shows the timestamp of the last audit trail record
processed before the DOC roll began. As the Collector processes audit
trail records, this column contains the current position in the audit trail. If
no audit trail records were processed, “NONE READ” appears.
START shows the time the DOC roll started if it is currently in progress,
otherwise it is blank.
DUR shows the number of minutes the current DOC roll has been in
progress. If no roll is in progress, DUR will appear blank.
STATE shows one of the following values:
ROLLING – roll in progress
WAIT CMD – anticipating NEXTDOC command
WAIT ADT – waiting for the audit trail to reach
SCHEDULE
WAIT TOD – waiting for system time to reach
SCHEDULE
Komentáře k této Příručce