HP Integrity NonStop H-Series Uživatelská příručka stáhnout pdf (Strana 278)

HP NonStop Shadowbase Command Definitions

Database Specification Command Descriptions

HP NonStop Shadowbase Command Reference Manual—785421-002

269

specified with the DICTVOL command will be used. If the DICTVOL

command has not been entered, the default volume and subvolume are

used. This is only needed if the TARGETREC parameter is specified.

TARGETFILE filename

Initial Changed

Version Version Values Default Value Specifications Alter

3.900 4.091 None Valid target file name Include NODE No

Is an optional parameter that identifies the name of the destination file. If

omitted and the Consumer CONNECTIONTYPE is not DIRECT and the

PATHNAME is omitted, the SOURCEFILE value is used as the target. If

omitted and a USEREXITID is specified or the Consumer

CONNECTIONTYPE is not DIRECT, it is assumed that the TARGETFILE

will be supplied by the user exit routine or is in PATHNAME. This name

can be the same as the source file. If volume and subvolume are not

entered, the default specified with the TARGETVOL command is used. If

the TARGETVOL command is omitted, the default volume and subvolume

are used. The filename can be a specific filename or a fileset selected by

using wildcard characters.

Indicate a fileset in the designation of the filename by using the following

wildcard characters for volume, subvolume and/or filename:

* (asterisk) matches from 0 to 8 characters in the position where it

appears. For example,

$D*.*.TABLE1

Indicates all files called TABLE1 found in all subvolumes on all

volumes that begin with the letter D

? cannot be used.

For partitioned TARGETFILEs, do not indicate $* for the volume, instead

indicate the exact name of the primary partition volume. Prefix and suffix

designators are supported for volume, subvolume and filename.

Notes:

 For Enscribe-to-Enscribe replication without DBS SOURCEREC and

TARGETREC parameters (DDL), the Consumer will now use the

minimum of the TARGETFILE record length or the audit trail event

length for the target I/O. Note that if ABENDONMISMATCH is set to

ON, this minimum setting is not performed and the audit trail event

length is used.

1 2 ... 273 274 275 276 277 278 279 280 281 282 283 ... 345 346

Žádné komentáře

HP Integrity NonStop H-Series Uživatelská příručka Strana 278