HP Integrity NonStop H-Series Uživatelská příručka stáhnout pdf (Strana 24)

HP NonStop Shadowbase Command Definitions

Monitor Command Descriptions

HP NonStop Shadowbase Command Reference Manual—785421-002

Monitor Command Descriptions

Monitor commands are associated with the definition and control of the HP

Shadowbase AUD Object. Commands are available to start and stop a

monitor, set limitations on the number of descriptions that can be entered,

specify logging requirements, and display configuration status.

These configuration control commands are described below.

ALTER AUD Command

The ALTER AUD command changes the settings for several important

elements of AUDMON previously established with the SET and START

AUD commands.

In the SET AUD Command description, there is a version box, as in the

samples below, with a column titled ‘Alter’ which is set to ‘Yes’ for those

parameters that can be altered while AUDMON is running. If the value

under ‘Alter’ is ‘No’ then these parameters cannot be altered once

AUDMON is running.

ADTWARNTDIFF seconds

Initial Changed

Version Version Values Default Minimum Maximum Alter

2.000 2.603 900 0 disable/1 32767 Yes

MAXCOLL number

Initial Changed

Version Version Values Default Minimum Maximum Alter

1.000 1 1 255 No

The syntax is:

ALTER [ AUD ] <audmon-name> { , aud_parameter }

[{ , aud_parameter } ]...

aud_parameter options can be found in the SET AUD section.

If you receive an error during an ALTER AUD command, do an INFO AUD

command to check values. Under certain circumstances, some parameter

values may change although an error appears.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 345 346

Žádné komentáře

HP Integrity NonStop H-Series Uživatelská příručka Strana 24