HP Integrity NonStop H-Series Uživatelská příručka stáhnout pdf (Strana 223)

HP NonStop Shadowbase Command Definitions

Database Specification Command Descriptions

HP NonStop Shadowbase Command Reference Manual—785421-002

214

RESET [ DBS ] [ dbs_parameter [ , dbs_parameter ] ... ]

dbs_parameter options can be found if the SET DBS section.

If dbs_parameter is omitted, values for all parameters are reset.

SET DBS Command

The SET DBS command establishes values for the attributes of a

database specification.

In each description, there is a version box. This box contains information,

as in the samples below.

Initial Changed

Version Version Values Default Minimum Maximum Alter

3.960 OFF OFF ON No

Initial Changed

Version Version Values Default Value Specifications Alter

3.900 3.964B None Valid target file name Include NODE No

To know if your version of HP Shadowbase can use the parameter, the

first column titled ‘Initial Version’, is for when the parameter was first

introduced. The next column is for if and when the parameter was last

changed. If the parameter has a last changed version then the values in

the columns following, are as of that version. The next column provides

the default value. Next is provided, either the minimum to maximum

values, or the listed value specifications. The value in the last column,

titled ‘Alter’, is set to ‘No’ as these parameters cannot be altered once

AUDCONS has been started. The Consumer must be stopped or the

DBS must be released to change the value of these parameters.

The syntax is:

SET [ DBS ] dbs_parameter [ , dbs_parameter ] ...

dbs_parameter options are described below:

ABENDONMISMATCH

Initial Changed

1 2 ... 218 219 220 221 222 223 224 225 226 227 228 ... 345 346

Žádné komentáře

HP Integrity NonStop H-Series Uživatelská příručka Strana 223