HP Modular Smart Array 500 Starter Kit Uživatelská příručka stáhnout pdf (Strana 93)

HP StorageWorks 2300 Modular Smart Array CLI reference guide 93

set host-parameters

Description For FC , sets controller host port parameters for communication with attached hosts. The new settings

take effect without restarting the controllers.

Syntax

set host-parameters [controller a|b|both] [speed 1g|2g|4g|auto] [ports #|all]

[fibre-connection-mode loop|point-to-point] [prompt yes|no|y|n|expert]

[noprompt]

Parameters controller a|b|both

Optional. Specifies whether to apply the settings to controller A, B, or both. Required if either speed

or fibre-connection-mode is specified.

speed 1g|2g|4g|auto

Optional. For FC, the link speed in Gbit/sec.

ports #|all

Optional. A host port number or all ports. If this parameter is omitted, all host ports on the specified

controllers are affected.

fibre-connection-mode loop|point-to-point

Optional. For FC, sets the topology for the specified ports to either:

• loop: Fibre Channel-Arbitrated Loop (public or private)

• point-to-point: Fibre Channel point-to-point.

noprompt

Optional. Specifies an automatic response to the confirmation prompt that enables the operation to

proceed. If this parameter is omitted, you must reply to the prompt.

Example On an FC storage system, set the link speed to 2 Gbit/sec for ports A1 and B1:

# set host-parameters speed 2g ports a1,b1

WARNING: This change will take effect immediately. Changes may affect access to

data. Are you sure? yes

Žádné komentáře

HP Modular Smart Array 500 Starter Kit Uživatelská příručka Strana 93