HP 7000 dl Router Series Uživatelská příručka stáhnout pdf (Strana 11)

100

101

SROS Command Line Interface Reference Guide Basic Mode Command Set

enable

Use the enable command (at the Basic Command Mode prompt) to enter the Enable Command Mode. Use

the disable command to exit the Enable Command Mode. See the section enable on page 11 for more

information.

Syntax Description

No subcommands.

Default Values

No default value necessary for this command.

Command Modes

> Basic Command Mode

Functional Notes

The Enable Command Mode provides access to operating and configuration parameters and should be

password protected to prevent unauthorized use. Use the

enable password

command (found in the Global

Configuration) to specify an Enable Command Mode password. If the password is set, access to the Enable

Commands (and all other “privileged” commands) is only granted when the correct password is entered.

Usage Examples

The following example enters the Enable Command Mode and defines an Enable Command Mode password:

enable

configure terminal

(config)#

enable password password

At the next login, the following sequence must occur:

enable

Password:

******

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 940 941

Komentáře k této Příručce

Žádné komentáře

HP 7000 dl Router Series Uživatelská příručka Strana 11

Komentáře k této Příručce

Související produkty a manuály pro Sítě HP 7000 dl Router Series