HP 7000 dl Router Series Uživatelská příručka stáhnout pdf (Strana 841)

100

101

SROS Command Line Interface Reference Guide HDLC Command Set

keepalive <seconds>

Use the keepalive command to enable the transmission of keepalive packets on the interface and specify

the time interval in seconds between transmitted packets.

Syntax Description

<seconds> Defines the time interval (in seconds) between transmitted keepalive packets

(valid range: 0 to 32,767 seconds).

Default Values

By default, the time interval between transmitted keepalive packets is 10 seconds.

Command Modes

(config-interface)# Interface Configuration Mode

Valid interfaces include: Ethernet (eth 0/1), virtual PPP interfaces (ppp 1), virtual

HDLC interfaces (hdlc 1), virtual Frame Relay sub-interfaces (fr 1.20), tunnel

interfaces (tunnel 1), and VLAN interface (vlan 1).

Functional Notes

If three keepalive packets are sent to an interface with no response, the interface is considered down. To

detect interface failures quickly, specify a smaller keepalive time.

Usage Examples

The following example specifies a keepalive time of 5 seconds on the HDLC interface:

(config)#interface hdlc 1

(config-hdlc 1)#keepalive 5

1 2 ... 836 837 838 839 840 841 842 843 844 845 846 ... 940 941

Komentáře k této Příručce

Žádné komentáře

HP 7000 dl Router Series Uživatelská příručka Strana 841

Komentáře k této Příručce

Související produkty a manuály pro Sítě HP 7000 dl Router Series