HP 7000 dl Router Series Uživatelská příručka stáhnout pdf (Strana 755)

100

101

SROS Command Line Interface Reference Guide PPP Interface Configuration Command Set

ip ospf

Use the ip ospf command to customize OSPF settings (if needed).

Command Modes

(config-interface)# Valid interfaces include: Ethernet (eth 0/1), virtual Frame Relay (fr 1), and virtual

PPP (ppp 1).

Syntax Description

authentication-key

Assign a simple-text authentication password to be used by other routers using

the OSPF simple password authentication.

cost <value>

Specify the OSPF cost of sending a packet on the interface. This value

overrides any computed cost value. Range: 1-65535.

dead-interval

Set the maximum interval allowed between hello packets. If the maximum is

exceeded, neighboring devices will determine that the device is down. Range:

0-32767.

hello-interval

Specify the interval between hello packets sent on the interface. Range:

0-32767.

message-digest-key

Configure OSPF Message Digest 5 (MD5) authentication (16-byte max) keys.

priority

<value>

Set the OSPF priority. The value set in this field helps determine the designated

router for this network. Range: 0-255.

retransmit-interval

Specify the time between link-state advertisements (LSAs). Range: 0-32767.

transmit-delay

Set the estimated time required to send an LSA on the interface. Range:

0-32767.

Default Values

retransmit-interval

5 seconds

transmit-delay

1 second

hello-interval

10 seconds: Ethernet, point-to-point, Frame Relay, and ppp

dead-interval

40 seconds

1 2 ... 750 751 752 753 754 755 756 757 758 759 760 ... 940 941

Komentáře k této Příručce

Žádné komentáře

HP 7000 dl Router Series Uživatelská příručka Strana 755

Komentáře k této Příručce

Související produkty a manuály pro Sítě HP 7000 dl Router Series