HP 7000 dl Router Series Uživatelská příručka stáhnout pdf (Strana 401)

100

101

SROS Command Line Interface Reference Guide Crypto Map IKE Command Set

set peer <address>

Use the set peer command to set the IP address of the peer device. This must be set for multiple remote

peers.

Syntax Description

<address> Enter the IP address of the peer device. If this is not configured, it implies

responder only to any peer.

Default Values

There are no default settings for this command.

Command Modes

(config-crypto-map)# Crypto Map Configuration Mode (IKE or Manual)

Functional Notes

If no peer IP addresses are configured, the entry will only be used to respond to IPSec requests; it cannot

initiate the requests (since it doesn't know which IP address to send the packet to). If a single peer IP

address is configured, the crypto map entry can be used to both initiate and respond to SAs.

The peer IP address is the public IP address of the device which will terminate the IPSec tunnel. If the peer

IP address is not static, the product cannot initiate the VPN tunnel. By setting no peer IP address, the

product can respond to an IPSec tunnel request in this case.

Usage Examples

The following example sets the peer IP address of 10.100.23.64:

(config-crypto-map)#set peer 10.100.23.64

1 2 ... 396 397 398 399 400 401 402 403 404 405 406 ... 940 941

Komentáře k této Příručce

Žádné komentáře

HP 7000 dl Router Series Uživatelská příručka Strana 401

Komentáře k této Příručce

Související produkty a manuály pro Sítě HP 7000 dl Router Series