HP 7000 dl Router Series Uživatelská příručka stáhnout pdf (Strana 307)

100

101

SROS Command Line Interface Reference Guide Global Configuration Mode Command Set

ip tftp source-interface <interface>

Use the ip tftp source-interface command to use the specified interface’s IP address as the source IP

address for TFTP traffic transmitted by the unit. Use the no form of this command if you do not wish to

override the normal source IP address.

Syntax Description

<interface> Enter the interface to be used as the source IP address for TFTP traffic.

Default Values

No default value is necessary for this command.

Command Modes

(config)# Global Configuration Mode required

Default Values

No default value is necessary for this command.

Functional Notes

This command allows you to override the sender field in the IP packet. If you have multiple interfaces in

your unit, changing the sender tells the receiver where to send replies. This functionality can also be used

to allow packets to get through firewalls that would normally block the flow.

Usage Examples

The following example configures the unit to use the loopback 1 interface as the source IP for TFTP

traffic:

(config)#ip tftp source-interface loopback 1

1 2 ... 302 303 304 305 306 307 308 309 310 311 312 ... 940 941

Komentáře k této Příručce

Žádné komentáře

HP 7000 dl Router Series Uživatelská příručka Strana 307

Komentáře k této Příručce

Související produkty a manuály pro Sítě HP 7000 dl Router Series