HP 7000 dl Router Series Uživatelská příručka stáhnout pdf (Strana 647)

100

101

SROS Command Line Interface Reference Guide ATM Sub-Interface Config Command Set

ATM SUB-INTERFACE CONFIG COMMAND SET

To activate the ATM Interface Configuration , enter the interface atm command (and specify a sub-interface) at

the Global Configuration Mode prompt. For example:

Router>

enable

Router#

configure terminal

Router(config)#

interface atm 1.1

Router(config-atm 1.1)#

The following commands are common to multiple command sets and are covered in a centralized section of this

guide. For more information, refer to the sections listed below:

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924

description on page 927

do on page 928

exit on page 930

ping <address> on page 931

show running-config on page 933

shutdown on page 935

All other commands for this command set are described in this section in alphabetical order.

access-policy <policyname> on page 648

atm routed-bridged [ip] on page 649

backup commands begin on page 652

bandwidth <value> on page 660

bridge-group <group#> on page 661

crypto map <mapname> on page 662

dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username> <password> on page 664

encapsulation [aal5mux | aal5snap] on page 666

fair-queue <threshold> on page 667

hold-queue <queue size> out on page 668

ip commands begin on page 669

mtu <size> on page 690

oam commands begin on page 691

pvc <VPI/VCI> on page 693

qos-policy out <mapname> on page 694

spanning-tree commands begin on page 696

1 2 ... 642 643 644 645 646 647 648 649 650 651 652 ... 940 941

Komentáře k této Příručce

Žádné komentáře

HP 7000 dl Router Series Uživatelská příručka Strana 647

Komentáře k této Příručce

Související produkty a manuály pro Sítě HP 7000 dl Router Series